Eskimo Shark Betreibershandbuch PDF herunterladen (Seite 9)

Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST 9

Operator’s Manual

51cc and 71cc Shark™ Power Ice Augers

Cooling Fins

Cooling ns, air inlets and linkages must be free from any debris

before each use.

Air Filter

Never run engine without air cleaner properly installed. Added wear

and engine failure may occur if air cleaner is not installed on engine.

Service air cleaner every 3 months or after 20 hours of operation.

Clean lter daily in extremely dusty conditions.

Steps for Cleaning Air Filter

1. Wash in warm water with mild soap until dirt and debris are

removed. Press lter when washing, do not twist.

2. Rinse in warm water until soap and dirt are removed.

3. Dry lter by wrapping in a clean cloth and pressing lter until

it is dry.

4. Apply oil to the entire lter.

5. Remove excess oil.

6. Attach the lter and air cleaner cover to the engine.

Spark Plug





1. Check spark plug every 50 operating hours.

2. Disconnect the spark plug cap, and clean any debris from

around the spark plug area.

3. Remove spark plug and replace if any of the following occur;

pitted electrodes, burned electrodes, cracked porcelain, or

deposits around electrodes.

4. After analysis, seat spark plug and tighten with spark plug

wrench.

 

 

engine) or .024” (71cc engine) and tighten additional 1/8 – 1/4

turn.

NOTE: Loose spark plug may overheat and damage engine.

Over tightened spark plug may damage threads in the

cylinder head.

TRANSPORTING YOUR ICE AUGER

1. Never transport engine inside an enclosed space or vehicle.

Fuel or fuel vapors may ignite causing serious injury or death.

2. If fuel is present in the fuel tank, transport in an open vehicle

in an upright position with the gas cap facing upwards.

3. If an enclosed vehicle must be used, remove gas into an

approved red fuel container. DO NOT siphon by mouth.

4. Run engine to use up the fuel in the carburetor and fuel tank.

Always run engine in a well ventilated area.

5. Wipe away any spilled fuel from engine and ice auger. Allow

to dry.

LONGTERM STORAGE

 

prepare it for long term storage.

Steps for Long-Term Storage

1. Add fuel stabilizer according to manufacturer’s instructions.

2. Run engine for 10-15 minutes to ensure that the stabilizer

reaches the carburetor.

3. Remove the remainder of the fuel from the gas tank into an

approved fuel container.

4. Remove auger from powerhead and apply a thin layer of

grease to the output shaft (8913).

5. Store auger and powerhead (engine) in a vertical position.

6. Remove all debris from auger and powerhead (engine).

7. Attach blade protector to bottom of auger.

CAUTION

AVOID INJURY! TO AVOID INJURY OR DEATH, NEVER

SIPHON FUEL BY MOUTH.

AVOID INJURY! NEVER STORE ICE AUGER WITH FUEL

IN THE GAS TANK INSIDE AN ENCLOSED AREA OR

BUILDING.

TO PREVENT ACCIDENTAL STARTING:

AVOID INJURY! ENGINE MUST BE TURNED OFF AND

COOL, AND SPARK PLUG WIRE MUST BE REMOVED

FROM SPARK PLUG BEFORE CHECKING AND

ADJUSTING ENGINE OR EQUIPMENT.

AVOID INJURY! AN ADULT MUST ALWAYS DO

MAINTENANCE AND REPAIR ON ENGINE AND AUGER.

AVOID INJURY! ENGINE MUST BE SHUTOFF, COOL,

AND SPARK PLUG WIRE REMOVED BEFORE ANY

REPAIR OR MAINTENANCE CAN BE DONE.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Eskimo Shark Betreibershandbuch Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Eiswürfelmacher Eskimo Shark