Eskimo Shark Betreibershandbuch PDF herunterladen (Seite 7)

Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST 7

Operator’s Manual

51cc and 71cc Shark™ Power Ice Augers

CAUTION

AVOID INJURY! ALWAYS HANDLE FUEL IN A WELL

VENTILATED AREA, OUTDOORS, AWAY FROM FLAMES

OR SPARKS.

AVOID INJURY! DO NOT START ENGINE IF FUEL IS

SPILLED. WIPE OFF EXCESS FUEL AND ALLOW TO DRY.

REMOVE ENGINE FROM AREA TO AVOID SPARKS.

AVOID INJURY! IF AUGER IS MOUNTED TO ENGINE,

ALL SAFETY GUARDS MUST BE SECURELY ON TO

AVOID SERIOUS INJURY.

AVOID INJURY! STARTER ROPE CAN CAUSE AN

UNANTICIPATED JERK TOWARDS ENGINE. PLEASE

FOLLOW INSTRUCTIONS TO AVOID INJURY.

AVOID INJURY! IF ENGINE FAILS TO START AFTER

TRYING STARTING PROCEDURES, PLEASE CONTACT

OUR CUSTOMER SERVICE DEPARTMENT AT 800345

6007 OR VISIT WWW.GETESKIMO.COM.

AVOID INJURY! NEVER LEAVE ENGINE RUNNING

WHILE UNATTENDED. TURN OFF AFTER EVERY USE.

AVOID INJURY! NEVER CARRY POWERHEAD AND

AUGER BETWEEN HOLES WHILE ENGINE IS RUNNING.

Cold Engine Start:

Starting engine for rst time or after engine has cooled o or

after running out of fuel.

1. Open gas cap vent screw all the way (counterclockwise).

2. Move choke lever to RUN or OFF position.

NOTE: Choke must be in the RUN or OFF position when

pushing or using the primer bulb.

3. Prime unit until primer tube is lled with gas.

NOTE: When using the primer bulb, allow the bulb to return

completely to its original position between pushes.

4. Move choke lever to CHOKE or ON position.

NOTE: CHOKE position is dened by moving the choke lever

as far to the ON position as possible.

5. Z71 ONLY: Depress compression release valve.

6. Push toggle switch to the ON position.

7. Grasp starter handle with left hand and pull out slowly, until

there is tension as you pull. Without letting starter handle

retract, pull rope with a rapid full arm stroke. Let it return

to its original position very slowly until the engine res or

runs, engage the throttle. When attempting to start, DO

NOT allow the recoil to retract on its own, as it may snap

back quickly and cause injury. Repeat this step every time

the starter rope is pulled.

NOTE: If engine fails to start after 5-6 pulls, push primer 1

time and pull starter rope again.

8. After engine starts running, move choke lever to HALF CHOKE

position until unit runs smoothly.

NOTE: HALF CHOKE is dened when the choke lever is

between CHOKE and RUN or ON and OFF.

9. Move choke lever to RUN or OFF position and move throttle

to desired speed.

NOTE: Run at full throttle when possible. Do not let unit

idle for extended periods of time.

10. To stop engine, push toggle switch to OFF position.

Warm Engine Start:

1. Open gas cap vent screw all the way (counterclockwise).

2. Move choke lever to CHOKE or ON position.

NOTE: CHOKE position is dened by moving the choke lever

as far to the ON position as possible.

3. Continue with Step 5 of Cold Engine Starting.

Hot Engine Start:

1. Open gas cap vent screw all the way (counterclockwise).

2. Continue with Step 6 of Cold Engine Starting.

3. If engine does not re, refer to Step 2 of Warm Engine Starting.

DO NOT attempt to start engine in the following ways:

• DONOTusestartinguid.

• DONOTsprayammableliquidsorvaporsintoaircleaner,

carburetor or spark plug chamber.

• DONOTremove sparkplugandpullonstarterrope.

Flammable fuel can spray out & ignite from a spark from

spark plug.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Eskimo Shark Betreibershandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Eiswürfelmacher Eskimo Shark